Photosynthesis and biochemical characterization of the green alga Chlamydopodium fusiforme (Chlorophyta) grown in a thin-layer cascade.

Photosynthesis, growth and biochemical composition of the biomass of the freshwater microalga Chlamydopodium fusiforme cultures outdoors in a thin-layer cascade were investigated. Gross oxygen production measured off-line in samples taken from the outdoor cultures was correlated with the electron transport rate estimated from chlorophyll a fluorescence measurements. According to photosynthesis measurements, a mean of 38.9 ± 10.3 mol of photons were required to release one mole of O2, which is 4.86 times higher than the theoretical value (8 photons per 1 O2). In contrast, according to the fluorescence measurements, a mean of 11.7 ± 0.74 mol of photons were required to release 1 mol of O2. These findings indicate that fluorescence-based photosynthesis rates may not be fully replace oxygen measurements to evaluate the performance of an outdoor culture. Daily gross biomass productivity was 0.3 g DW L-1 day-1 consistently for 4 days. Biomass productivity was strongly affected by the suboptimal concentration at which the culture was operated and by the respiration rate, as the substantial volume of culture was kept in the dark (about 45% of the total volume). As the cells were exposed to excessive light, the photosynthetic activity was mainly directed to the synthesis of carbohydrates in the biomass. In the morning, carbohydrate content decreased because of the dark respiration. Per contra, protein content in the biomass was lower at the end of the day and higher in the morning due to carbohydrate consumption by respiration. The data gathered in these trials are important for the future exploitation of Chlamydopodium fusiforme as a potential novel species in the field of microalgae for the production of bio-based compounds.

Photosynthesis Monitoring in Microalgae Cultures Grown on Municipal Wastewater as a Nutrient Source in Large-Scale Outdoor Bioreactors.

Microalgae cultures were used for a WW treatment to remediate nutrients while producing biomass and recycling water. In these trials, raceway ponds (RWPs; 1 and 0.5 ha) were located next to a municipal (WW) treatment plant in Mérida, Spain. The ponds were used for continuous, all-year-round microalgae production using WW as a source of nutrients. Neither CO2 nor air was supplied to cultures. The objective was to validate photosynthesis monitoring techniques in large-scale bioreactors. Various in-situ/ex-situ methods based on chlorophyll fluorescence and oxygen evolution measurements were used to follow culture performance. Photosynthesis variables gathered with these techniques were compared to the physiological behavior and growth of cultures. Good photosynthetic activity was indicated by the build-up of dissolved oxygen concentration up to 380% saturation, high photochemical yield (Fv/Fm = 0.62-0.71), and relative electron transport rate rETR between 200 and 450 µmol e- m-2 s-1 at midday, which resulted in biomass productivity of about 15-25 g DW m-2 day-1. The variables represent reliable markers reflecting the physiological status of microalgae cultures. Using waste nutrients, the biomass production cost can be significantly decreased for abundant biomass production in large-scale bioreactors, which can be exploited for agricultural purposes.

Effect of the Application of Hydrolysate of Chlorella vulgaris Extracted by Different Techniques on the Growth of Pelargonium × hortorum.

The extraction method used to obtain biologically active compounds from microalgal biomass may affect the biostimulant capacity of the microalgae. The objective of this assay was to determine the most efficient extraction method to release the active components of the biomass of Chlorella vulgaris (C. vulgaris). Plantlets of Pelargonium × hortorum were grown in a greenhouse and five treatments were applied: C-application with water; M-application with untreated C. vulgaris microalgae; M-US-application with C. vulgaris microalgae treated with ultrasound; M-USHY-application with C. vulgaris microalgae treated with ultrasound and enzymatic hydrolysis; and M-USHYAU-application with C. vulgaris microalgae treated with ultrasound, enzymatic hydrolysis, and autoclaving. All microalgae treatments increased shoot number and stem and plant diameter. The US-treated biomass increased the inflorescence of the plant significantly compared to the control. To extract bioactive compounds from eukaryotic microalgae for plant biostimulating purposes, the US-treatment (or any other method damaging the plasma membrane) of microalgae cell is, or seems to be, suitable.. Macronutrient content in leaves was not affected by the microalgae treatment, except for K.

Annual assessment of the wastewater treatment capacity of the microalga Scenedesmus almeriensis and optimisation of operational conditions.

The depth of the culture and the dilution rate have a striking effect on the biomass productivity and the nutrient recovery capacity of microalgal cultures. The combination of culture depth and dilution rate that allows to maximise the performance of the system depends on environmental conditions. In the current study, a response surface methodology was used to explore the relationship between the two most relevant operational conditions and the biomass productivity achieved in 8.3 m2 pilot-scale raceways operated using urban wastewater. Four polynomial models were developed, one for each season of the year. The software predicted biomass productivities of 12.3, 25.6, 32.7, and 18.9 g·m-2·day-1 in winter, spring, summer, and autumn, respectively. The models were further validated at pilot-scale with R2 values ranging within 0.81 and 0.91, depending on the season. Lower culture depths had the advantage of minimising nitrification and stripping but allow to process a lower volume of wastewater per surface area. Biomass productivity was higher at culture depths of 0.05 m, when compared to 0.12 and 0.20 m, while the optimal dilution rate was season-dependent. Results reported herein are useful for optimising the biomass productivity of raceway reactors located outdoors throughout the year.

Modeling of photosynthesis and respiration rate for microalgae-bacteria consortia.

In this article, the influence of culture conditions (irradiance, temperature, pH, and dissolved oxygen) on the photosynthesis and the respiration rates of microalgae-bacteria consortia in wastewater treatment was analyzed. Specifically, some short photo-respirometric experiments, simulating outdoor raceway reactors, were performed to evaluate the response of microalgae, heterotrophic bacteria, and nitrifying bacteria to variations in environmental parameters. Results demonstrate that irradiance is the most dominant variable to determine microalgae photosynthesis rates. However, reduction in microalgae activity was not observed at higher irradiance, ruling out the existence of photoinhibition phenomena. Related to heterotrophic and nitrifying bacteria, their activities were strongly affected by the influence of temperature and pH. Moreover, the effect of dissolved oxygen concentrations on microalgae, and bacteria activities was studied, displaying a reduced photosynthetic rate at dissolved oxygen concentrations above 20 mg/L. Data have been used to develop an integrated model for each population (microalgae, heterotrophic bacteria, and nitrifying bacteria) based on considering the simultaneous influence of irradiance, temperature, pH, and dissolved oxygen. The models fit the experimental results in the range of culture conditions tested, and they were validated using data obtained by the simultaneous modifications of the variables. These individual models serve as a basis for developing a global biologic microalgae-bacteria model for wastewater treatment to improve the optimal design and management of microalgae-based processes, especially outdoors, where the cultures are subject to variable daily culture conditions.

BIO_ALGAE 2: improved model of microalgae and bacteria consortia for wastewater treatment.

A new set up of the integral mechanistic BIO_ALGAE model that describes the complex interactions in mixed algal-bacterial systems was developed to overcome some restrictions of the model. BIO_ALGAE 2 includes new sub-models that take into account the variation of microalgae and bacteria performance as a function of culture conditions prevailing in microalgae cultures (pH, temperature, dissolved oxygen) over daily and seasonal cycles and the implementation of on-demand dioxide carbon injection for pH control. Moreover, another aim of this work was to study a correlation between the mass transfer coefficient and the hydrodynamics of reactor. The model was calibrated using real data from a laboratory reactor fed with real wastewater. Moreover, the model was used to simulate daily variations of different components in the pond (dissolved oxygen, pH, and CO2 injection) and to predict microalgae (XALG) and bacteria (XH) proportions and to estimate daily biomass production (Cb). The effect of CO2 injection and the influence of wastewater composition on treatment performance were investigated through practical study cases. XALG decreased by 38%, and XH increased by 35% with respect to the system under pH control while microalgae and bacteria proportions are completely different as a function of influent wastewater composition. Model simulations have indicated that Cb production (~ 100 gTSS m-3 day-1 for manure and centrate) resulted lower than Cb production obtained using primary influent wastewater (155 gTSS m-3 day-1).